How Does Wear Leveling Make Your SSD Live Longer?

In a previous blog, we looked at some of the most basic technologies that make SSDs and their Flash NAND chips work more efficiently and thus live longer. But there is one thing we have not discussed: wear leveling.

What is wear leveling

Without wear leveling, an SSD would generally never reach its optimal lifespan. Since an SSD consists of many Flash NAND cells and each of them is only capable of a certain amount of read-/write- operations, an SSD would normally fail without wear leveling much quicker than with this technology.

This is because technology is based on algorithms that make sure that each Flash NAND storage cells are used equally. A cell can only handle 3000 – 100,000 read-/write cycles. But even this high amount of cycles can be reached relatively soon.

Wear leveling in more detail

Without wear leveling algorithms, the flash controller must permanently assign the logical addresses from the operating system to the physical addresses of the Flash memory. That means that every new write to a previously written block must first be read, erased, modified and re-written to the first location. Not only is this approach highly time-consuming, but it also means that some storage spaces will be used more frequently than others and wear out faster. When a few blocks reach their end of life, the device can become inoperable and data loss is likely to occur.

Wear leveling algorithms

By using wear leveling algorithms the SSD controller distributes the write operations in such a way that all NAND memory cells are written to equally. There are two different ways this is accomplished: static wear leveling and dynamic and static wear leveling.

Simply put, dynamic wear leveling means that the SSD controller takes the least used free flash blocks to write data to. Even though this method is a little bit better than no wear leveling at all, when a lot of data is stored on an SSD the cells still wear out more quickly. That is why (hopefully) an additional method is used - static wear leveling. This method helps to reduce the wear of the flash cells over the entire capacity of the built-in FLASH chips by shifting the data to less used flash blocks.

Conclusion

Wear leveling is one of the most essential technologies to expand the lifetime of an SSD. Therefore when buying a new SSD it is essential that you choose one where both methods of wear leveling – dynamic and static – are implemented in the firmware. By doing so, you not only choose a product with a better life expectancy but also invest in data security. When both wear leveling methods are used, the more unlikely a data loss situation due to hardware failure will occur.

More about:

SSD Data Recovery

Share Print Page

By Device

By Solution

By Industry

Data Recovery

Tape Services

Data Destruction

Other Services

Ontrack EasyRecovery

Ontrack Desk

Data Erasure Software

Data Erasure Hardware

Ontrack PowerControls

Ontrack Partner Program

Technology Partners

Technology Partners